Where it goes
Apparel is the largest user: plackets, cuffs, waistbands, pocket flaps and adjustable tabs, where the tape replaces buttons, zips and press studs and keeps the closure flat against the body.
The same tape goes into medical supports, sports braces, footwear and bag flaps — anywhere the closure has to open and close thousands of times without losing grip.
Specification
| Model | VC-261 |
|---|---|
| Material | Nylon |
| Colour | black |
| Minimum order | 500 m for stock shades, 3,000 m for a custom dye lot |
| Sampling & lead time | Samples in 7 days; bulk 2-3 weeks after the lab dip is approved |
| Slitting tolerance | ±0.5 mm on slit width |
| Certification | SGS, Oeko-Tex Standard 100, ISO 9001 |
| Packing | Polybag inside export carton; retail-ready packing on request |
| Origin | Xiamen, Fujian, China |
Processing options
- Cut-to-length rolls — wound to the metreage your cutting room works in, so nothing is re-measured on the table.
- Paired supply — hook and loop shipped as matched sets, tested as a pair rather than as separate rolls.
- Slitting — from 10 mm up, ±0.5 mm, in any number of width splits from one master roll.
- Edge finish — woven selvedge as standard, heat-sealed on request where the edge is exposed.
Quality control
Width, closure force and colour are measured on a sample from the start, middle and end of every production run. Peel and shear are tested on the matched hook and loop pair, not on single rolls. Non-conforming lots are held, not shipped.
Common questions
What is the minimum order? 500 m for stock shades and 3,000 m for a custom dye lot. Smaller trial quantities from stock widths are possible — tell us the width and the annual volume.
How long does it take? Samples ship in 7 days. Bulk runs take 2-3 weeks after the lab dip is approved.
What tolerance do you hold on slit width? ±0.5 mm. If your line needs a tighter band, say so when you send the drawing — it changes how the roll is wound, not just how it is cut.
Can you match a sample we already use? Yes. Send the sample or the peel and shear figures you work to. And We will match the construction and the closure force rather than just the colour.
